1 After using a glass cutter slices, sliced clear eyelash bar will be attached to the blade, and rinse with distilled water in the syringe.
2 adhered debris can also be sharpened cleaning rod removed.
Glass cutter blades with alcohol wipe to remove grease, then insert the top of the cleaning rod into a 45 ° cone, the cleaning rod after 50% ethanol and humid, Maguo entire blade in one direction, can not scrub back and forth, the best in dissecting microscope proceed.
This washing step is not necessary, in the case of application of the adhesive with only fragments.
3 may become difficult to wet glass cutter knife, the knife can be immersed in a 1% Tween 20 or 1% Triton X-100 solution or a mild detergent diluted in 3-5 hours and then rinsed with distilled water. This usually can solve this problem.
4 After washing glass cutter, when it is wet it should be placed on the specific case.
5 cans or gas pressure is not available at the knife edge blowing, because of the small particles or organic contaminants such as oil may affect the molecular glass cutter blade. |
